• Up to 06 loads per hour *

• Min: 36”W x 36”L x 10”H
• Max: 48”W x 48”L x 80”Hx

• 4,000 lbs. to 6,000 lbs ***

i>200”W X 135 #8221;L X 102½#8221;H**

• 4,750 lbs.

• 230V/3/60 20A

Controls:

• Allen Bradley SLC 5_03 PLC
• 24V control system
• Current overload protection
• Allen Bradley AC variable frequency drives
• Autoheight sensing photoeye with on_off mode
• Power on_off lockable switch and indicator light
• One E-Stop on switch board
• Two emergency stop stations beside I_O conveyors
• Allen Bradley monochrome Touch Panel
• Separate up and down carriage speed
• Separate top and bottom wrap selection (0-9)
• Film force to load control
• Alarm beacon
• Manual clamp jog (located beside table - user friendly)
• Reset function
• Manual function for table fwd_rev., carriage up_down
• All conveyor sections with independent forward_reverse
• On screen intuitive alarm diagnostic
• Air pressure switch
• Non proprietary parts
• 120 VAC outlet in control panel for service work
• Double brush dust tight slip ring

• 20 inch Econo NO-THREAD® Powered Pre-Stretch
• 1 HP AC motor with VFD , chain & sprocket driven
• 50-300% prestretch ratio (preset to customer spec, Std 200%)
• Electronic film tension control with analog sensor
• Sensing device for film out/broken with visual alarm
• Lexan roller cover for operator safety
• Film force release for easy pull at start and end of cycle

• ¾ HP AC motor with Allen Bradley variable frequency drive
• Two #50 carriage lifting chains
• Dual ½” CRS ways with UHMW-PE carriage glides

• Automatic film clamping device
• Pulsed controlled cutter
• Film alignment arm
• Brush-on film tail treatment
• Heat seal optional ***

• 15 RPM variable speed (22 RPM available) ***
• 1½ HP AC motor with Allen Bradley variable frequency drive
• Lexan roller cover for operator safety