• Up to 50 loads per hour *

• 56”W x 56”L x 80”H (80” diagonal)

• Unlimited

• 130”W X 135 1/2” L X 119 7_8”H**
  

• 2,300 lbs.

• 120V/1/60 15A (other voltages available upon request)

• 3 CFM @ 80 PSI with FR

Controls:

• Allen Bradley Micrologix 1200 PLC
• 24V control system
• Current overload protection
• Nema 4_12 control cabinet with quick disconnect
• Autoheight sensing photoeye with on/off mode
• Power on/off lockable switch and indicator light
• Large E-stop (push pull type)
• Variable rotary arm speed (12 RPM) other speeds available
• Separate up and down carriage speeds
• Separate top and bottom wrap selection (0-9)
• Pull cord switch with 40 feet of cable (to be installed by customer)
• Positive arm alignment controlled by proximity sensor
• Film force to load control
• Double brush dust tight slip ring
• Emergency stop sensor for arm path obstruction
• Dynamic braking system for rotary arm with AC drive
• Manual clamp jog
• Manual function for rotation fwd_rev. and carriage up_down
• Top cover pause switch (splash proof program)
• Reinforce wrap_manual rotation control

• 20” Econo NO-THREAD® Powered Pre-Stretch
• 1 HP AC motor with VFD , chain & sprocket driven
• 50-300% prestretch ratio (preset to customer spec, Std 200%)
• Electronic film tension control with analog sensor
• Lexan roller cover for operator safety
• Film force release for easy pull at start and end of cycle
• Angled carriage to wrap approximately 4” from floor level

• ¾ HP AC motor with Allen Bradley variable frequency drive
• Two #50 chain carriage lifts for safety
• Dual 1/2” CRS ways with UHMW-PE carriage glides
• Dual structural steel supporting boom
• Power track for efficient guiding of wires

• Automated cut_clamp & wipe system
• Pulsed controlled cutter
• Film alignment arm
• Brush-on film tail treatment

• 25” Heavy duty Ring GEAR Bearing, with Pinion GEAR Drive
• 12 RPM variable speed
• 3_4 HP AC motor with variable frequency drive
• Electronic soft start_stop
• Positive turntable alignment controlled by proximity sensor
• Protection guard over the ring gear bearing
• Dynamic braking system with AC drive

• Floor mounting integrated design (10 anchor points)
• All structural steel construction. 10” square tubing column
• Heavy duty structural steel construction
• Easy access to all components

• Wulftec recommends using heavy-duty expansion shields of 3/4” diameter thread size with a minimum anchor depth of 4” in concrete.

• The machine is provided with a manual including electro_mechanical schematics and drawings
• Trouble shooting guide
• Installation instructions

• 3-year unlimited cycle warranty
• 10-year warranty on 25” ring gear bearings
• 10-year warranty on structural frame
• Lifetime warranty on prestretch rollers' blue compound